Installing The Options; Installing The Plug-In Boards - Sony MVS-8000A-C Installation Manual

1-4. Installing the Options

The MVS-8000A-C/MVS8000AS-C is shipped from the
factory with the necessary option boards (refer to the
following table) already installed in accordance with the
specified system configuration.
The following options are available for the MVS-8000A/
8000ASF.
MVS-8000A/8000ASF Option List
Model name
MKS-8160A
(MVS-8000A only)
24 Output Board
MKS-8162A
(MVS-8000ASF only)
12 Output Connector Board
MKS-8210A
Mix/Effect Board
MKS-8440A
Frame Memory Board
MKS-8170A
DME Interface Board
MKS-8420A
Color Correction Board
MKS-8161M
(MVS-8000A only)
8 Monitor Output Board
MKS-8110M
17 Input Board
MKS-8111M
(MVS-8000A only)
Additional 12 Input Board
HK-PSU04
Power Supply Unit
BZS-8250 *
Simple P/P Software
* : BZS-8250 is the software options.
1-4
Board configuration
Plug-in board Connector board
OUT-28 board CNO-25 board
CNO-25 board _
MIX-48A board _
MY-112B board _
DIF-141 board _
_
CC-90 board
_ CNO-24 board
_
CNI-22 board
_ CNI-23 board
_ _
_ _

1-4-1. Installing the Plug-in Boards

c
Be sure to turn off the POWER switch before starting
installation work.
If installation work is started with the POWER switch left
on, it may cause electrical shock or damage to printed
circuit boards.
Each plug-in board of the Production Switcher Processor
MVS-8000A/8000ASF is allocated to a specific slot into
which they must be installed. Check to see that the respec-
tive plug-in boards are installed in their respective slots.
The name of the board is shown near the eject lever at the
right-most end of each plug-in board.
Names of the plug-in boards and the slot numbers, to
which the plug-in boards are allocated, are shown on the
Extract PWB stopper assembly inside the front panel of the
MVS-8000A/8000ASF. Install the respective plug-in
boards according to this instruction.
m
. Check to see that connectors of the plug-in boards are
securely inserted into the mother board (MVS-8000A :
MB-1014 board, MVS-8000ASF : MB-1034 board)
without loose contact.
If any plug-in board is inserted into the incorrect slot, it
causes a system error and the system will not work
correctly.
. After installing the plug-in board, the software must be
installed. Install the software of V4.20 or later version.
For installing the software, refer to the user's guide of
the MVS-8000A/8000ASF system.
MVS-8000A/8000ASF