6.18.4 To replace the SIM card, 420/440 only as
accessory
For communication circuit boards that have a separate
SIM card and not an e-SIM.
®
1. Deactivate Automower
Connect in the display
®
Accessories > Automower
Connect .
menu
2. Remove the communication circuit board. Refer to
To replace the communication circuit board, 420/440
only as accessory on page 29 .
3. Slide the hatch to the SIM card holder and open the
hatch.
1
2
4. Remove the SIM card from the holder.
5. Install a new SIM card in the holder.
6. Install in opposite sequence.
Note: The HMI cable must be connected in correct
direction.
7. Switch on the product.
8. Connect to Autocheck.
9. Reset the Communcation circuitboard in Autocheck.
Note: When you reset the communication circuit
board, the geofence settings are set to default and
the phone numbers are deleted.
®
10. Activate Automower
Connect in the display menu
®
Accessories > Automower
Connect . The function is
active after 5 minutes.
6.18.5 To replace the ultrasonic sensors 450X/
450XH/550/550H
To remove and install
1. Remove the body. Refer to
the body on page 20 .
To replace the top
2. Remove the top cover. Refer to
cover 430X/430XH/450X/450XH/520/550/550H on
page 22 .
30 - Repair instructions