Download Print this page

Kenmore 106.4673 Series Use & Care Manual page 12

Bottom mount refrigerator
Hide thumbs Also See for 106.4673 Series:

Advertisement

Available languages

Available languages

IMPORTANT:
To comply
with American
Disabilities
Act (ADA)
guidelines,
fully
retract
the rollers into the cabinet
to lower the
refrigerator.
Door Closing
The base grille covers the leveling
screws and roller assemblies
located
at the bottom
of the refrigerator
cabinet
below the freezer
drawer.
Before
making
adjustments,
remove the base grille and
move the refrigerator
to its final location.
1.
Remove the base grille. Grasp
the grille firmly
and pull it
toward
you.
2.
Move the refrigerator
to its final location.
NOTE:
To allow the refrigerator
to roll easier, raise the leveling
legs off the floor
by turning
the leveling
screws
counterclockwise.
The front rollers will be touching
the floor.
3.
So the doors will close easier, use a 1/4" hex driver
to turn both
leveling
screws clockwise.
This will raise the front of the
refrigerator
tilting
it slightly
downward
to the rear. Turn both
leveling
screws the same amount.
NOTE: Having
someone
push against
the top of the refrigerator
takes some weight
off the leveling
screws. This makes it easier
to turn the screws.
A.
leveling
screw
B. Front
roller
4.
5.
Open
both doors again to make sure they close as easily as you
like and that they stay closed.
If not, tilt the refrigerator
slightly
more to the rear by turning
both leveling
screws to the right.
It
may take several
more turns.
NOTE:
To keep the refrigerator
level, you should turn both
leveling
screws the same amount.
Replace
the base grille.
Pull open the freezer
drawer.
Align
the three clips on the back of the base grille with the
three tabs at the base of the refrigerator.
Push the base grille in toward
the refrigerator
until it is
firmly
in place.
A. Tab
B. Clip
Door Alignment
If the space between
the refrigerator
doors and freezer
drawer
looks uneven, you can adjust
it using the following
instructions:
1.
Remove the top hinge cover.
2.
Loosen the top hinge screws using a _6"
socket or wrench.
3.
Have someone
hold the door in place or put a spacer
between
the doors and drawer.
4.
Tighten
the top hinge screws once the door is in the desired
location.
5.
Replace
the top hinge cover.
FILTERS AND ACCESSORIES
The air filter
reduces the buildup
of odors. This helps to maintain
a
cleaner
environment
inside the refrigerator.
On some models, your
refrigerator's
accessory
packet
includes
an
air filter, which must be installed
prior to use. On some models,
the
air filter
is already
installed
at the factory.
Installing
the Air Filter
Install the air filter
behind
the vented
door, located
along the rear
interior
wall of the refrigerator
compartment.
1.
Remove the air filter
from its packaging.
NOTE: An air filter status indicator
is included
with the air filter.
The indicator
is not needed
for models that display
the air filter
status on the control
panel.
Page 12

Advertisement

loading