Table of Contents
Advertisement
SET-UP
FINE TUNING
If the reception is clear, you do not have to fine-tune the channel, because this is done
automatically during auto program and manual memory.
If, however, the signal is weak or distorted, you may have to fine-tune the channel manually.
1. Press CH
/
buttons or use the number buttons to select a channel you want to adjust.
2. Press MENU button, move the cursor to "SETUP" option and press VOL + button. The "SET
UP" menu is displayed.
MENU
PICTURE
SOUND
TIME
SET UP
FUNCTION
LANGUAGE : ENGLISH
: SEL. + : ENTER
: EXIT
3. Press CH
/
buttons to place the cursor on the "FINE TUNE" option.
4. Use VOL + / - buttons until you obtain a sharp and clear picture and good sound quality.
SETUP
ANTENNA
: CATV2
AUTO PROGRAM
FINE TUNE
: 0
LNA
: ON
A/D: MEMORY
: SEL.
: ADJ
: PREV.
5. If you wish to memorize the fine-tuned frequency for the channel, press ADD/DEL button. The
[
] symbol (red color) appears to the right of the channel number. To delete the memory,
press the same button again. The [
] symbol disappears.
NOTES
The AFT (Automatic Fine Tuning) mode does not operate on the channels that are
fine-tuned.
After the Auto Channel Programming has been performed, memorized channels
are automatically tuned to their optimum frequencies.
16
All manuals and user guides at all-guides.com
SETUP
ANTENNA
: CATV2
AUTO PROGRAM
FINE TUNE
: 0
LNA
: ON
A/D: MEMORY
: SEL.
: ADJ
: PREV.
SETUP
ANTENNA
: CATV2
AUTO PROGRAM
FINE TUNE
: +2
LNA
: ON
A/D: MEMORY
: SEL. + : ADJ
: PREV.
SET-UP
LNA (Low Noise Amplifier) EFFECTS
Set LNA ON to increase a weak incoming signal. However, if you are located in a strong signal
area, such as nearby a broadcasting station, and if the picture is distorted, set LNA OFF.
1. Press CH
/
buttons or use the number buttons to select a channel you want to adjust.
2. Press MENU button, move the cursor to "SETUP" option and press VOL + button. The "SET
UP" menu is displayed.
MENU
PICTURE
SOUND
TIME
SETUP
FUNCTION
LANGUAGE : ENGLISH
: SEL. + : ENTER
: EXIT
3. Press CH
/
buttons to place the cursor on the "LNA" option.
4. Press the VOL+ button.
Whenever this button is pressed, the mode will change as follows.
SETUP
ANTENNA
: CATV2
AUTO PROGRAM
FINE TUNE
: 0
LNA
: OFF
: SEL. + : SET
: PREV.
17
SETUP
ANTENNA
: CATV2
AUTO PROGRAM
FINE TUNE
: 0
LNA
: OFF
: SEL. + : SET
: PREV.
SETUP
ANTENNA
: CATV2
AUTO PROGRAM
FINE TUNE
: 0
LNA
: ON
: SEL. + : SET
: PREV.
Advertisement
Table of Contents
