Specifications; Preamp Section - Peavey TransTube Series Operating Manual

POWER AMPLIFIER SECTION:
Power @ Clipping: (Typically)
(5% THD, 1 kHz, 120V AC line)
40W RMS into 6 Ohms
Frequency Response:
+0, -2 dB 100 Hz to 20 kHz @ 35W RMS
into 6 Ohms
Hum and Noise:
Greater than -86 dB below rated power
Power Consumption:
75W @ 60 Hz, 120V AC, Domestic
75W @ 50/60 Hz, 220-230/240V AC, Export

PREAMP SECTION:

The following specs are measured @ 1 kHz with the
controls preset as follows:
Channel Select, Clean
Clean Mode Switch, Modern
Low and High @ 10
Mid @ 0
Lead Pre and Post Gain @ 10
Lead Mode Switch, Vintage
Reverb @ 0
Nominal Levels are with Clean Volume @ 5
Minimum Levels are with Clean Volume @ 10
Preamp High Gain Input:
Impedance: High Z, 250 K Ohms
Nominal Input Level: -13 dBV, 225mV RMS
Minimum Input Level: -22 dBV, 82mV RMS
Maximum Input Level: +0 dBV, 1V RMS
Specifications subject to change without notice.
All manuals and user guides at all-guides.com
ENVOY

SPECIFICATIONS

12
® 110
Preamp Low Gain Input:
Impedance: High Z, 44k Ohms
Nominal Input Level: -7dBV, 450mV RMS
Minimum Input Level: -16dBV, 164mV RMS
Maximum Input Level: +6dBV, 2V RMS
Headphone Output:
Load Impedance: 16 Ohms or greater
Nominal Output Level: -3 dBV, 0.7V RMS
System Hum and Noise @ Nominal Input Level:
(20 Hz to 20 kHz unweighted)
Greater than 78 dB below rated power
Equalization:
Special Low, Mid, and High passive type EQ.
Modern/Vintage switch (Clean):
Two distinct EQ voicings.
Vintage/Modern/High Gain switch (Lead):
Three different EQ and Gain voicings
External Footswitch Functions:
Select: Clean or Lead channel selection.
Reverb: Reverb bypass
Dimensions (H x W x D):
16" H x 18.13" W x 9.5" D
40.1cm x 46.1cm x 24.1cm
Weight:
21.7 lbs. (9.84 kg)