Tascam owner manual portable dj cd/mp3 player cd-dj1 (28 pages)
Summary of Contents for Tascam MP-BT1
Page 1
» MP-BT1 MP3 Bass Trainer Quick Start Guide D00998301A This device has a serial number located on the rear panel. Please record it and retain it for your records. Serial number: __________________...
(servicing) instructions in the literature accompanying the appliance. TASCAM MP-BT1 FOR U.S.A. TO THE USER This equipment has been tested and found...
1–Introduction Thank you for purchasing the TASCAM MP-BT1. This unit is ideal for use when practicing bass. If you run into a phrase on a recording that is too difficult for you to learn by ear at ordinary speed, you can play and loop the music at a slower speed to study the part.
TASCAM/TEAC service center. Getting detailed usage of the MP-BT1 The MP-BT1 has an Owner’s Manual in its internal memory in PDF format. The Owner’s Manual covers all the operations of the unit in detail, while the included Quick Start Guide helps you for the basic operations.
MENU About the power supply The MP-BT1 uses a built-in lithium ion battery that can be recharged by connecting the unit to a computer with the USB cable. You can also use an AC adapter (sold separately) to power the unit and recharge the battery.
1–Introduction Reset hole If the MP-BT1 starts to operate incorrectly, insert the end of a paper clip or similar object into this hole to press the System Reset Button inside. Pressing this button turns the power OFF. NOTE Do not press the System Reset Button if the unit is operating normally.
POWER arrow and hold it until “ TASCAM screen. Release the switch. The MP-BT1 starts and the home screen appears. To turn the MP-BT1 power off: Slide the switch in the direction of the POWER arrow and hold it until “...
On the computer, you should find the unit shown as an external drive named “MP-BT1.” NOTE When shipped from the factory, an Owner’s Manual is stored in the MP-BT1 drive in PDF format in the MANUAL folder. 2–Preparing tracks Copying tracks from a computer Click on the “MP-BT1”...
Connect headphones or a monitoring system (an amp with built-in speakers, a home stereo, etc.) using the / jack. LINE OUT Playing back tracks on the MP-BT1 Press the key to start playback. Á/π Press the key again to stop playback.
If VSA is set to ON on the PB CONTROL screen, the pitch stays the same even when the tempo is changed. 5. Press the the home screen. and press TEMPO key. ENTER key twice to return to MENU TASCAM MP-BT1...
IN and OUT LOOP points are kept, so you can play the same loop if you press the key again. LOOP If you press the key, the loop IN and OUT points are cleared. TASCAM MP-BT1 LOOP...
4–Playing bass with the MP-BT1 You can connect a bass and mix your bass playing with the track you are playing back. Connecting a bass Connect a bass to the BASS IN Adjust the bass volume with the Bass Guitar...
4–Playing bass with the MP-BT1 Using the built-in effects The MP-BT1 has built-in bass effects. 1. Press the key to open the screen. 2. Use the wheel to select key. ENTER 3. Use the wheel to choose a bank and press the key.
Need help?
Do you have a question about the MP-BT1 and is the answer not in the manual?
Questions and answers