Download Print this page

Import Nt S Fegu Rds - Black & Decker Avant Steam F990 Use And Care Book Manual

Black & decker vant steam iron manual
Hide thumbs

Advertisement

5. l terminar, suelte el botón, coloque la plancha sobre el talón de descanso
y enchúfela. Permita que la plancha se caliente unos dos minutos hasta secar
toda el agua sobrante.
LM CEN MIENTO DE L PL NCH
1. Desconecte la plancha y espere que se enfríe.
2. Verifique que el selector de tejidos esté ajustado a la posición "0".
3. Enrolle el cable e insertelo en el enganche del enchufe
hasta que quede seguro en su lugar (M).
4. lmacene la plancha verticalmente sobre el talón de
descanso, a fin de evitar el goteo a través de la suela.
M
7

IMPORT NT S FEGU RDS

When using your iron, basic safety precautions should always be followed,
including the following:
❑ RE D LL INSTRUCTIONS BEFORE USING.
❑ Use iron only for its intended use.
❑ To protect against a risk of electric shock, do not immerse the iron in
water or other liquids.
❑ The iron should always be turned to "0" before plugging or unplugging
from outlet. Never yank cord to disconnect from outlet; instead grasp plug
and pull to disconnect.
❑ Do not allow cord to touch hot surfaces. Let iron cool completely before
putting away. Loop cord loosely around the iron when storing.
❑ lways disconnect iron from electrical outlet when filling with water or
emptying and when not in use.
❑ Do not operate iron with a damaged cord or if the iron has been dropped
or damaged. To avoid the risk of electric shock, do not disassemble
the iron, take it to a qualified serviceman for examination and repair.
Incorrect reassembly can cause a risk of electric shock when the iron is
used.
❑ Close supervision is necessary for any appliance being used by or near
children. Do not leave iron unattended while connected or on an ironing
board.
❑ Burns can occur from touching hot metal parts, hot water or steam. Use
caution when you turn a steam iron upside down - there may be hot
water in the reservoir.
SPECI L INSTRUCTIONS
❑ To avoid a circuit overload, do not operate another high-wattage
appliance on the same circuit.
❑ If an extension cord is absolutely necessary, a 15-ampere cord should be
used. Cords rated for less amperage may overheat. Care should be taken
to arrange the cord so that it cannot be pulled or tripped over.
S VE THESE INSTRUCTIONS.
8

Advertisement

loading

  Related Manuals for Black & Decker Avant Steam F990

This manual is also suitable for:

Avant steam f995