Page 2
3 AAA Alkaline batteries (for use with alarm unit) This user’s guide DEFCON 3 AT A GLANCE The DEFCON 3 Security System provides a number of options through its programmable features - the electronic motion sensor, the alarm siren sound, and alarm volume.
Page 3
Provide visual warning and alarm status ACTIVATING THE ALARM UNIT The DEFCON 3 Security System is designed to work with a specific remote control. To activate the alarm unit, you must first transmit a signal from its remote control device. Once the alarm unit has received the unique remote control ID code, it only responds to that remote control and ignores other signals.
Installing Batteries Figure 3. Installing Batteries in the Alarm Unit 1. Unscrew the end of the cable to detach it. 2. Remove the screw and battery cover from the back of the alarm unit. 3. Insert the batteries in place as shown in Figure 3. 4.
You will hear one chirp, and the left LED light will flash (once per second) indicating the unit is active If the DEFCON 3 detects excessive motion while armed, it warns with a continuous tone, then sounds a loud siren for 30 seconds. The alarm unit resets itself against additional threats.
PROGRAMMING DEFCON 3 FEATURES The DEFCON 3 has a Program Mode that enables you to tailor the alarm unit to your personal preferences through several advanced features. Accessing Program Mode 1. Make sure the alarm unit is not armed. 2. Press and hold the Program button on the remote control...
Page 9
Setting Motion Sensitivity The DEFCON 3 alarm unit has two sensitivity settings: Low Motion Sensitivity (Level 1): First then This setting triggers the alarm siren when the unit has detected continuous motion for six seconds. This is the factory default.
4. Press and hold the Program button to advance to the next programmable feature - alarm siren. Setting Alarm Siren Your DEFCON 3 Security System provides a selection of six different alarm siren sounds. 1. Access Program Mode. The alarm siren is the third feature you encounter in Program Mode.
Program Mode will be saved. Alarm Unit Low Battery Warning Your DEFCON 3 Security System warns you when it detects a low battery condition. Upon arming or disarming your alarm unit, you will hear an extended low tone in addition to the usual one or two beeps. When you hear this tone, replace the batteries as soon as possible.
SPECIFICATIONS Power: Current Consumption (Armed/Disarmed): 0.16 - 1.6 mA Current Consumption (Tripped): 60 mA Batteries: Alarm: Three (3) AAA Alkaline 1.5 Volt Remote Control: One (1) ANSI/NEDA 1811A or equivalent Battery Life: Alarm: up to 90 days with cable secured or 3 years with cable unsecured Remote Control: 2 years Alarm Dimensions: 16 mm (.63 inches) thick...
TROUBLESHOOTING Should you encounter any difficulties in operating your DEFCON 3 Security System, review the following list of common problems and solutions. If the problem remains unresolved, please contact our technical support team. Problem Solution System does not operate Ensure batteries are properly installed in both the remote control and the alarm unit;...
WARRANTY Targus warrants this product to be free from defects in material and workmanship for one year. If your Targus DEFCON 3 is found to be defective within that time, Targus will repair or replace it. This warranty does not cover damage from everyday wear and tear, or from transportation by a common carrier.
Need help?
Do you have a question about the DEFCON 3 and is the answer not in the manual?
Questions and answers