Connecting The Monitor; Ac Power Connection; Signal Cable Connection - LG 99T User Manual

Connecting the Monitor

On the back of the monitor are three plug-in connections; one for the
AC power cord, and the others for the signal cable from the video card.

1. AC Power Connection

One end of the AC power cord is connected into the AC power connector
on the back of the monitor. The other end is plugged into a properly
grounded three-prong AC outlet. The monitor's auto-sensing power supply
can automatically detect 100-120V AC or 200-240V AC, 50 or 60Hz.

2. Signal Cable Connection

The connectors for the signal cable are located on the back of the
monitor. The BNC and 15 pin VGA connectors on the back of the
monitor allow for a wide variety of video controllers to be connected to
the monitor. Examples of signals that might be sent to the monitor
include signals from IBM PC and compatibles, Apple Macintosh,
Centris, Quadra, and SPARC workstations.
The supplied signal cable consists of 15 pin VGA connectors at both
ends, suitable for connections to an IBM PC or compatible.
Other generic cables or adapters may be used for connections to your
equipment, as long as they meet the compatible signal requirements
to activate this monitor (see page 24 for input specifications). For
Apple Macintosh use, a separate plug adapter is needed to change
the 15 pin high density (3 row) D-sub VGA connector on the supplied
cable to a 15 pin 2 row connector. Examples of typical connections
are shown below. Select the connection example that fits your needs.
5