Tanaka TPH-200 Owner's Manual

Tanaka TPH-200 Owner's Manual

Pole hedgetrimmer attachment
Hide thumbs Also See for TPH-200:

Advertisement

Model Numbers:
TPH-200
TPH-200
TPH-200
TPH-200
TPH-200
POLE HEDGETRIMMER A
POLE HEDGETRIMMER A
POLE HEDGETRIMMER ATT
POLE HEDGETRIMMER A
POLE HEDGETRIMMER A
ISM, Inc. • 1028 4
www.tanakapowerequipment.com
TTA A A A A CHMENT
TT
TT
TT
Supplier To The Outdoor Power Equipment Industry
Street SW • Auburn, WA 98001 • Phone: (253) 333-1200 • Fax: (253) 333-1212
th
Owner'
Owner' s Man
Owner'
Owner'
Owner'
CHMENT
CHMENT
CHMENT
CHMENT
TPH-200
s Man
s Man ual
s Man
ual
ual
ual
s Man
ual
P/N
30350
Date 05-21-01
custsvc@tanaka-ism.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TPH-200 and is the answer not in the manual?

Questions and answers

Barry Maguire
May 10, 2025

Will start but will not rev up to cut.

1 comments:
Mr. Anderson
May 20, 2025

If the Tanaka TPH-200 starts but does not rev up to cut, a likely cause is incorrect carburetor adjustment. The manual advises checking the carburetor adjustment during maintenance to ensure proper engine performance.

This answer is automatically generated

Subscribe to Our Youtube Channel

Summary of Contents for Tanaka TPH-200

  • Page 1 Model Numbers: TPH-200 TPH-200 TPH-200 TPH-200 TPH-200 POLE HEDGETRIMMER A POLE HEDGETRIMMER A POLE HEDGETRIMMER ATT POLE HEDGETRIMMER A POLE HEDGETRIMMER A ISM, Inc. • 1028 4 www.tanakapowerequipment.com Owner’ Owner’ s Man Owner’ Owner’ Owner’ TTA A A A A CHMENT...
  • Page 2 Do not touch the blade when running the engine. www.tanakapowerequipment.com TPH-200 WARNING It is important that you read, fully understand and observe the following safety precautions and warnings. Careless or improper use of the unit may cause serious or fatal injury.
  • Page 3 1. Introduction It is important that you read and understand your TANAKA brush cutter owner's manual as well as this manual. Please carefully review and observe all safety precautions and warnings. Careless or improper use of the unit may cause serious or fatal injuries.
  • Page 4: Assembly Procedures

    2. Loosen wing nut (1) and knob nut (2) slightly so that the support handle (3) slides. 3. Adjust the blade angle to desired position by holding the support handle (3). Then, finger-tighten the knob nut (2) securely and also the wing nut (1). www.tanakapowerequipment.com TPH-200 Owner’s Manual custsvc@tanaka-ism.com...
  • Page 5 3. With the bolts set at that position, tighten the cutter fixing nuts. Be sure to replace cutter guide fixing bolts when they are loosened, worn or damaged. Also be sure to replace damaged cutter blade. NOTE! Properly lubricate the cutter sliding surfaces with machine oil. www.tanakapowerequipment.com TPH-200 Owner’s Manual custsvc@tanaka-ism.com...
  • Page 6 TPH-200 Owner’s Manual www.tanakapowerequipment.com custsvc@tanaka-ism.com...

Table of Contents