15. Be careful during cleaning not to get the engine or start switch wet, as this may cause the electrical system to short circuit. If the engine or switch becomes wet, dry before use. tanaka-usa.com TS-720 E-Z Tiller™ Owner’s Manual custsvc@tanaka-ism.com...
Take a minute or two to familiarize yourself with each component of the E-Z Tiller listed below. The only tool you'll need to assemble the E-Z Tiller is an allen wrench, and we've included one tanaka-usa.com TS-720 E-Z Tiller™ Contents of Shipping Carton 1 - E-Z Tiller Frame...
There are three (3) holes in the stabilizer bar for different cutting depths. Refer to p. 9, under “Tilling and Cultivating Hints," for more details. NOTE- The piece extending downward from the carrying handle is the stabilizer bar. tanaka-usa.com TS-720 E-Z Tiller™ Owner’s Manual FIG. 3) custsvc@tanaka-ism.com...
To secure the two inner tines, insert the snap pins through the inner (1) set of holes in the shaft. tanaka-usa.com TS-720 E-Z Tiller™ (FIG. 10) Start with the left side. Select the tine that is stamped with a "B". Install the tine (on the left tine shaft) with the hub facing to the left (outward).
2. Operating Controls tanaka-usa.com TS-720 E-Z Tiller™ NOTE. Fig. 11 shows the location of the operating controls of your Excel E-Z Tiger. For your safety, we strongly recommend that you become familiar with their functions before using the machine.
5. NOTE: When the engine stalls from lack of fuel, repeat the "Cold Starting" procedures. Stopping The Engine (FIG. 11 & 11A) Decrease the engine speed by releasing the throttle lever (1), then turn the stop switch (2) to the "OFF" position. tanaka-usa.com TS-720 E-Z Tiller™ Owner’s Manual custsvc@tanaka-ism.com...
2. Do not charge battery when the temperature is below 32 ° F (0° C) or above 113° F (45° C). In extreme temperatures, the battery may not accept a full charge. NOTE: When completely discharged, the battery will take approximately 15 hours to charge. tanaka-usa.com TS-720 E-Z Tiller™ Owner’s Manual custsvc@tanaka-ism.com...
NOTE: A stiff throttle wire may cause high idling speed. Oil/spray the wire when needed. If the wire is still stiff, it may need to be replaced. tanaka-usa.com TS-720 E-Z Tiller™ Owner’s Manual custsvc@tanaka-ism.com...
23.7 fl. oz. / 700 cc Battery Pack 4.8V DC rechargeable Charging System Internal (ignition coil) also AC/120V unit (back-up) Air Cleaner Oiled Foam Elements (2) Handle 2-piece folding Stabilizer Bar Standard Carrying Handle Standard tanaka-usa.com ism.com TS-720 E-Z Tiller™ Owner’s Manual custsvc@tanaka-...
Tines Won’t Turn Tines Rotate when throttle is released Unit does not till properly Engine does not idle tanaka-usa.com ism.com TS-720 E-Z Tiller™ Battery is low Switch not on Incorrect wiring Incorrect Starting Procedure No spark on spark plug Not enough fuel...