Advertisement
Table of Contents
Model Numbers:
T T T T T CP-25, T
CP-25, T
CP-25, T
CP-25, T
CP-25, T CP-210
T T T T T CP-381
CP-381
CP-381
CP-381
CP-381
PUMPS
PUMPS
PUMPS
PUMPS
PUMPS
ISM, Inc. • 1028 4
www.tanakapowerequipment.com
CP-210
CP-210
CP-210
CP-210
Supplier To The Outdoor Power Equipment Industry
Street SW • Auburn, WA 98001 • Phone: (253) 333-1200 • Fax: (253) 333-1212
th
Owner'
Owner'
Owner' s Man
Owner'
Owner'
TCP-210
s Man
s Man
ual
ual
s Man ual
ual
s Man
ual
P/N
25121
Date 05-12-01
custsvc@tanaka-ism.com
Advertisement
Table of Contents
Related Manuals for Tanaka TCP-210
Summary of Contents for Tanaka TCP-210
- Page 1 Owner’ s Man Owner’ Owner’ Supplier To The Outdoor Power Equipment Industry Street SW • Auburn, WA 98001 • Phone: (253) 333-1200 • Fax: (253) 333-1212 s Man s Man s Man ual s Man 25121 Date 05-12-01 TCP-210 custsvc@tanaka-ism.com...
-
Page 2: Before Using This Unit
It is important that you read, fully understand and observe the following safety precautions and warnings. Careless or improper use of the unit may cause serious or fatal injury. Owner’s Manual custsvc@tanaka-ism.com... - Page 3 Use the instructions that apply to your unit. 1. Carrying Handle 2. Delivery Port 3. Priming Plug 4. Suction Port 5. Drain Plug 6. Throttle Lever 7. Base 8. Choke Lever 9. Recoil Starter 10. Air Cleaner 11. Fuel Tank Fuel Cock www.tanakapowerequipment.com TCP-25/210/381 Owner’s Manual custsvc@tanaka-ism.com...
-
Page 4: Warnings And Safety Instructions
Indicates a strong possibility of severe personal injury or loss of life, if instructions are not followed. CAUTION! Indicates a possibility of personal injury or equipment damage, if instructions are not followed. NOTE! Helpful information for correct function and use. www.tanakapowerequipment.com TCP-25/210/381 Owner’s Manual custsvc@tanaka-ism.com... -
Page 5: Assembly Procedure
4. Operating Procedures Fuel Always use branded 89 octane unleaded gasoline. Use Tanaka two-cycle oil or a quality two-cycle oil at mixing ratio of 25-50:1 (Gasoline (A) : Oil (B)), only for the state of California at 50:1. Never use multi-grade oil (10 W/30) or waste oil. - Page 6 After the pumping of seawater, chemical fluid or urine, wash the pump with fresh water. Stopping (Fig. 2-6, 6B) When the engine is to be stopped, gradually decrease the engine speed to an idle, and then stop the engine. The engine is stopped, by completely raising the throttle lever. www.tanakapowerequipment.com custsvc@tanaka-ism.com...
-
Page 7: Maintenance
If this machine was originally equipped with resistor spark plug, use same type of spark plug for replacement. Muffler (Fig. 3-4) Remove the muffler and clean out any excess carbon from the exhaust port or muffler inlet from time to time in order to avoid power-loss. Owner’s Manual custsvc@tanaka-ism.com... -
Page 8: Maintenance Schedule
Clean the air filter. Monthly maintenance Rinse the fuel tank with gasoline, and clean fuel filter. Clean the exterior of the carburetor and the space around it. Clean the fan and the space around it. www.tanakapowerequipment.com TCP-25/210/381 Owner’s Manual custsvc@tanaka-ism.com... - Page 9 287 x 219 x 288 mm 85.1 91.9 Owner’s Manual TCP-381 51 ml 1.65 kW / 5,500 min Float type NGK BM-6A or BMR-6A 1.2 l 300 l /min. 40 m 1.5” (38 mm) 9.5 kg 398 x 300 x 382 mm 91.1 98.3 custsvc@tanaka-ism.com...
-
Page 10: Declaration Of Conformity
Tanaka Kogyo Co.,Ltd.,3-4-29 Tsudanuma,Narashino,Chiba,Japan Declare under our sole responsibility that the product, engine pump model to which this declaration relates is in conformity with the essential safety requirements of directives. 89/392/EEC, 91/368/EEC, 93/44/EEC, 93/68/EEC, EMC89/336/EEC The following standards have been taken into consideration.