Maintenance Safety Maintain the engine and equipment according to recommended procedures. www.tanakapowerequipment.com PF-2600 Owner’s Manual Read, understand and follow all warnings and instructions in this manual and on the unit. Disconnect the spark plug before performing maintenance except for carburetor adjustments.
Fuel Always use branded 89 octane unleaded gasoline. Use Tanaka two-cycle oil or a quality two-cycle oil at mixing ratio of 50:1 (Gasoline (A) : Oil (B)). Never use multi-grade oil (10 W/30) or waste oil. Always mix fuel and oil in a separate clean container.
Rinse it in warm soap suds. Check that the filter is dry before reassembly. An air filter that has been used for some time cannot be cleaned completely. Therefore, it must regularly be replaced with a new one. A damaged filter must always be replaced. www.tanakapowerequipment.com PF-2600 Owner’s Manual custsvc@tanaka-ism.com...
Page 5
Do not operate engine with engine shroud or muffler guard removed as this will cause overheating and engine damage. www.tanakapowerequipment.com PF-2600 Fuel Filter (Fig. 3-2B) Drain all fuel from fuel tank and pull fuel filter line from tank. Pull filter element out of holder assembly.
Page 7
U.S. EPA PHASE 1 / STATE OF CALIFORNIA EMISSION CONTROL WARRANTY STATEMENT THE CALIFORNIA AIR RESOURCES BOARD AND TANAKA KOGYO CO., LTD. ARE PLEASED TO EXPLAIN THE EMISSION CONTROL SYSTEM WARRANTY ON YOUR TANAKA ENGINE. NEW SMALL OFF ROAD ENGINES MUST BE DESIGNED, BUILT AND EQUIPPED TO MEET STRINGENT CALIFORNIA ANTI-SMOG STANDARDS.