Advertisement
Quick Links
WHOLE hoUSE VENTILATOR
PRODUCT MANUAL & INSTALLATION GUIDE
your home. Above a central hallway or at the top of a stairwell will provide the best airflow.
Make sure that there aren't any pipes, wires, rafters or air conditioning or heating ducts running through
the space where the GHOST will be installed. The GHOST can NOT be mounted vertically.
Make sure that you have adequate exhaust area out of your attic. This can be accomplished with
a combination of roof, ridge or gable end vents. The GHOST requires a minimum of 9 square feet of attic exhaust area.
If your home has an engineered roofing system, care should be taken that the GHOST will fit within the truss layout.
Tamarack Technologies, Inc.• 320 Main Street • Buzzards Bay, MA 02532
508-759-4660 • 800-222-5932 • Fax 508-759-6001 • www.tamtech.com
Serial Number
Date of Purchase
Point of Purchase
The serial number is located on the shipping carton
and on a label affixed to an insulated door.
When you have unpacked your GHOST
carefully you will find the following:
One (1) GHOST
One (1) White Metal Grille w/(6) Screws
One (1) Hand Held Remote Transmitter
One (1) Remote Receiver w/ line cord & interconnect cable
The GHOST should be installed in your attic in a central location within
GH.02
Advertisement
Related Manuals for Tamarack Technologies GH.02
Summary of Contents for Tamarack Technologies GH.02
- Page 1 If your home has an engineered roofing system, care should be taken that the GHOST will fit within the truss layout. Tamarack Technologies, Inc.• 320 Main Street • Buzzards Bay, MA 02532 508-759-4660 • 800-222-5932 • Fax 508-759-6001 • www.tamtech.com...
- Page 2 You will need the following items: two pieces of 2x stock to match your existing framing, a saw to cut the hole in the ceiling, a ham- mer or screw gun to attach the blocking to the existing joists, a Phillips head screw driver to attach the grille, weather strip mate- rial and low expansion spray foam sealant.
- Page 3 6. Rotate the upper housing until it lines up with the lower housing. Make sure the edges of the two hous- ings mate all the way around the GHOST (Figure 6) and then pull the black attachment handles down over their attachment posts (Figure 7).
- Page 4 If, within the period of three years from the date of purchase, the GHOST (the Product) is defective or malfunctions in normal home use, Tamarack Technologies, Inc. will repair or replace the Product, at its discretion. Customer is responsible for shipping charges.