Cisco Firepower 1010 Hardware Installation Manual page 32

Wall-Mount the Chassis
Figure 24: Attach the Wall-Mount Bracket to the Chassis
Step 4 Use the two Cisco-provided screws to drill into a stud, or use the anchors from the dry-wall kit to hang it into dry wall.
If you are mounting the chassis onto something other than drywall, such as wood or sheet metal, anchors may not be
required.
Step 5 Drill a hole into the wall at each mark that you made in Step 2.
These holes should be slightly smaller in diameter than anchors if you are using them. The recommended drill hole size
is 3/16 inches.
Step 6
Insert the anchors into the holes if needed, and be sure they are properly seated.
Step 7 Fasten each screw into its anchor until it protrudes about 1/4 inch.
Step 8
Pick up the chassis, align the screws in the anchors with the holes in the bottom of the wall-mount bracket, move the
chassis toward the wall until the screw heads are in the wall-mount bracket, and then slide it down until it rests on the
screws.
Caution Do not mount the chassis with the rear panel facing downward. This orientation is not supported.
What to do next
Install the cables according to your default software configuration as described in the
for your software version.
Cisco Firepower 1010 Hardware Installation Guide
28
Mount the Chassis
Getting Started Guide