Honeywell Miller RACDTA-5K6/6FT User Instruction Manual page 11

- Use a proper drill & bit for concrete. (SDS drill bit)
- Drill a 7/8" (22mm) hole no less than 3" to 3-1/2" (76mm-89mm) deep 9" (229mm)
away from any edge.
- Hole must be straight & perpendicular to surface.
- Hole must be free of debris
- Concrete strength must be at least 3000psi (20.7MPa) and no less than 7" (178mm)
thick.
-Drop expansion sleeve into hole.
-Use the Setting Tool by placing it in the hole resting on the expansion sleeve. Tap
tool until the blue inner sleeve is at the bottom of the expansion sleeve.
-Now place swivel over the hole and install the bolt provided.
Expansion
Sleeve
Us er Ins tru ct ion s - Engl is h
CONCRETE MOUNTING
3/4" (19mm)
drill
Setting Tool
(DNC-TOOL)
Ø
11
7"
(178mm)
min.
Torque Range:
30-40 ft-lbs
(22-30Nm)