Download  Print this page

Troubleshooting; Introduction; Self Test - PHILIPS 50 A Series Instructions For Use Manual

Fetal monitors.
Hide thumbs

Advertisement

Introduction

Self Test

Chapter 15 - Troubleshooting
Common problems that may occur during monitoring are dealt with in
the relevant chapters in this book. This chapter describes:
The Self Test
The Quick Test
The Parameter Test, including:
– Ultrasound Test
– Toco Test
– IUP Test
If a non-fatal error occurs (for example, if the batteries are low):
– An error message is displayed for ten seconds.
– Err xxx
ten seconds, and after that every ten minutes.
(" xxx " represents the number of the error message.)
– Switch the monitor off and then on. If the error occurs again,
try to solve the problem or, if you cannot, contact your
Philips Service Engineer or Response Center.
If a fatal error occurs (for example, if a board is defective):
– An error message is displayed for ten seconds.
– After ten seconds, the monitor tries to restart.

Troubleshooting

, time and date are printed on the paper after
15
113

Advertisement

Table of Contents

   Also See for PHILIPS 50 A Series

This manual is also suitable for:

50 ip-2 seriesM1351aM1353a

Comments to this Manuals

Symbols: 0
Latest comments: