Service; Maintenance - Keysight 42941A Operation And Service Manual

Service

Maintenance

5 Service
This chapter provides information on servicing and proper maintenance.
Serial Number for Non-RoHS 42941A: "MY431xxxxx and below" / "SG431xxxxx
and below"
Serial Number for RoHS 42941A: "MY432xxxxx and above" / "SG432xxxxx and
above"
Maintenance
An exploded view of the 42941A for parts identification is shown in
and
technical difficulties in RoHS soldering, only parts and support level that do
not require RoHS soldering are supported. Replace all defective parts with the
"RoHS Compliant Replacement Part No.". Do not disassemble any further than
shown. Maintenance consists principally of cleaning contacts and replacing
worn or damaged parts. Take special care when cleaning contacts.
To order parts, use the Keysight Technologies part numbers listed in
and
disassembled, order the next higher assembly or return the fixture to the
nearest Keysight Technologies Sales/Service Office for repair or replacement.
Keysight 42941A Impedance Probe Kit
Figure 5-2. Due to limited availability of RoHS compliance station and
Table 5-2. If a faulty part is located in an assembly that cannot be
Figure 5-1
Table 5-1
7