Samsung DW80M9 Series User Manual page 11

Hi-Temp Wash
5
Sanitize /
6
( Control Lock)
Display
7
Delay Start
8
DW9900M_DD68-00184A-06_EN.indd 11 DW9900M_DD68-00184A-06_EN.indd 11
Raises the main wash temperature to improve cleaning for loads containing tough, baked-on
food.
Hi-Temp Wash is not available for the Delicate and Rinse Only cycles.
With the Sanitize option selected, the water temperature is increased to 163 ˚F (73 ˚C) in the
fi nal rinse cycle for high temperature sanitization.
If you select the Sanitize option, the "Sanitize" lamp blinks when the water temperature reaches
the sanitary temperature (over 155 ˚F (68 ˚C)), and then remains illuminated until the Sanitize
option ends. When you open the door or press the Power button, the "Sanitize" lamp turns off .
You cannot select the Sanitize option if you select the Delicate and Rinse Only cycles.
The Sanitize feature operates in accordance with NSF/ANSI Standard 184 for Residential
Dishwashers. Certifi ed residential dishwashers are not intended for licensed food
establishments. Your dishwasher is NSF Certifi ed.
Only the Heavy cycle with the Sanitize option has been designed to meet the requirements for
soil removal and sanitization effi cacy in NSF 184.
Control Lock allows you to lock the buttons on the control panel so children cannot accidently
start the dishwasher by pressing the buttons on the panel.
To lock and unlock the buttons on the control panel, hold the Sanitize button down for three (3)
seconds when the power is On.
Displays cycle time and remaining hours and minutes, Delay Start hours, and Information
codes. If a problem occurs during operation, an information code appears with a warning
sound. Refer to the information codes page.
Control Lock indicator
- Turns on if the Control Lock is set (or the dishwasher is in the standby or pause
modes).
- Turns off while the dishwasher is operating.
- When Control Lock is on, the Control Lock indicator blinks for several seconds if any
button except the Power button is pressed.
Self Clean indicator
- Turns on when the Self Clean option is enabled (or the dishwasher is in the standby
or pause modes), but turns off while the dishwasher is operating.
- Blinks for 5 seconds every 20 to 22 cycles.
- The cycle counter disappears when the Self Clean operation is complete or when
the dishwasher reaches the 23rd cycle without the Self Clean cycle being used.
(The Cancel or Self Clean operation is not counted by the cycle counter.)
Rinse Refi ll indicator
- Turns on if the dishwasher runs out of rinse aid (or the dishwasher is in the standby
or pause modes).
- Turns off while the dishwasher is operating.
Delay a cycle for up to 24 hours in one-hour increments. To increase the delay start time, press
or hold the Delay Start button. The hour displayed indicates the time at which the wash will
start.
- After setting the delay time, press the Start button, and then close the door to start the
cycle.
- If you want to change the delay time once the dishwasher has started, press the Cancel
button and turn off the dishwasher. Then, turn on the dishwasher again and select a new
cycle with a new delay setting.
English - 11
2018-10-12 2018-10-12 11:55:13 11:55:13