Husqvarna L 321AH Operator's Manual page 15

5. Move the product a minimum of 3 m (10 ft) from the
position where you filled the tank before a start.
To set the cutting height
The cutting height can be adjusted in 9 levels.
1. Push the cutting height control in the direction of the
wheel and then rearward to increase the cutting
height.
2. Push the cutting height control in the direction of the
wheel and then forward to decrease the cutting
height.
CAUTION: Do not set the cutting height too
low. The blades can hit the ground if the
surface of the lawn is not level.
To start the product
1. Stay behind the product.
2. Hold the engine brake handle against the handlebar.
3. Hold the starter rope handle with your right hand.
4. Slowly pull out the starter rope until you feel some
resistance.
5. Pull with force to start the engine.
WARNING: Do not twist the starter rope
around your hand.
1240 - 001 - 08.07.2019
To use the drive on the wheels
• Pull the drive levers in the direction of the handlebar.
• Before you pull the product rearward, disengage the
drive and push the product forward approximately
10cm.
• Release the drive levers to disengage the drive, for
example when you go near an obstacle.
To adjust the drive control cable
• Use the adjuster screw to adjust the drive control
cable.
• Turn off the engine. Always disconnect the spark
plug before you operate the movable parts.
• Turn the adjustment screw counterclockwise to
tension the wire and increase the speed.
• Turn the adjustment screw clockwise to extend the
wire and reduce speed.
To stop the product
• To stop the drive only, release the drive levers.
9