Setting-Up Operation; Using The Radio- Controlled Socket; Using The Remote Control; Deleting A Code - Silvercrest RC DP3 4001-A GB 3726 Operation And Safety Notes

Deleting a code:

To delete a code, first repeat steps
1–3.
With the LED operating display
flashing, press the desired OFF
button of the channel ON/ OFF
button (A, B, C or D) you wish
2
to delete on the remote control.
The LED operating status display
will flash rapidly for approx. 2 sec-
onds to confirm deletion.
It will then flash slowly again for
approx. 30 seconds and a new
code entered.
Deleting all codes:
To delete all codes, first repeats
steps 1–3.
Then with the LED operating status
display flashing, press the
5
ALL-OFF button
control. The LED operating status
display will flash rapidly for
5
approx. 2 seconds to confirm dele-
tion, then go out.

Setting-up operation

Q
U sing the radio-
Q
controlled socket (fig. B)
1. Put the radio-controlled socket into
any shuttered socket and connect
the appliance you want to operate.
2. Switch the electrical appliance on.
The radio-controlled socket can
only perform its switching function
when the device to be controlled is
switched on.
5
5
on the remote
3
ATTENTION! FIRE HAZARD!
Do not attach any appliances which
could cause fires or other damaged
if left unattended when switched
on. The maximum load of every
radio-controlled socket is approx.
3000 W. Any overload could cause
a risk of fire or damage to the device.
Using the remote
Q
control (fig. A)
The remote control will control up to 4
remote-controlled sockets (individually,
in groups or simultaneously).
1. Press the desired ON button of the
channel ON / OFF button
B, C or D) on the remote control of
the device you wish to switch on.
The LED status light
erating control lamp
2. Press the desired OFF button of the
channel ON / OFF button
B, C or D) on the remote control for
the device you wish to switch off.
The LED operating status display
will go out.
3. Confirm the ALL ON / OFF button
to switch all remote-controlled
3
sockets simultaneously.

Troubleshooting

Q
If the remote control does not
work, please check the follow-
ing points:
(A,
2
and the op-
5
will light up.
1
(A,
2
5
GB/IE/NI 11