Advertisement
11. Undercharged lead-acid batteries
will freeze during cold weather.
Do not test or charge a frozen battery.
12. When connecting the Battery Cables to the
battery, avoid creating sparks; especially when
the battery is being charged. Explosive gases
are created during charging. Sparking could
also damage the vehicle electrical system.
13. Do not touch the cooling vents on the Battery
Tester during or immediately after testing
the battery. They become very hot.
14. When placing the Battery Tester in the vehicle's
engine compartment, take special care that
the metal housing of the Tester does not
come in contact with either terminal of the
battery or other electrical connections.
Specifications
Testing
6 and 12 VDC
Capability
Load Test
100 amps;
Capacity
200 ~ 1000 cold cranking amps
Meter Display
Analog, 0 ~ 16 VDC (max.)
Functions
Black Negative
cable clamp
Item 61945
SAVE THESE INSTRUcTIONS.
Handle
Switch
For technical questions, please call 1-888-866-5797.
15. Be certain of the test battery polarity before
connecting the test Cable Clamps. The red Cable
Clamp goes to the positive terminal of the battery.
The black Cable Clamp goes to the negative
terminal of the battery. Reversing Battery Tester
Cable Clamps on the battery will damage the tester.
16. Do not drop the Battery Tester as it
may affect proper operation.
17. Do not smoke or have open flames near the battery.
18. Do not connect the Battery Tester to
the battery while the engine is running.
Turn the engine off before connecting.
19. The warnings and precautions discussed in this
manual cannot cover all possible conditions and
situations that may occur. It must be understood
by the operator that common sense and caution
are factors which cannot be built into this
product, but must be supplied by the operator.
10 seconds per test with
Test Cycle
1 minute cool down;
3 tests in 5 minutes
Battery Cable
18" long including clamps
Clamps
Copper plated
Red positive
cable clamp
Meter
Display
Page 3
Advertisement
