Subscribe to Our Youtube Channel
Related Manuals for EV4 City Quad
Summary of Contents for EV4 City Quad
- Page 1 Battery installing guide for EV4 City Quad Remove all side screws from the battery cover Remove the rear main bolt from the battery cover...
- Page 2 Remove the front main bolt from the battery cover Lift the battery cover and remove it completely together with the controller. The cables are not connected.
- Page 3 On the front and rear of the battery casing there are cables going into the casing. Because the battery is a tight fit you need to remove the cables with the rubber protection and move them out of the way. The case is now ready to insert the battery.
- Page 4 This is how the battery looks after it is correctly inserted Once the battery is inserted reinsert the cables back into the casing making sure that the rubber protection is in place. Next, attach the casing cover with the front main bolt (picture on the right). Tighten the nut for now to keep the cover in upright position.
- Page 5 All relevant cables have been marked with numbers to help with proper connection. Connect them carefully. Cables that don’t have a number don’t need to be connected to anything. We recommend using small amount of isolation tape to wrap all of the connectors. This is to ensure that they don’t disconnect or short circuit during use.
- Page 6 Loosen the front main bolt and close the cover. Secure the cover with rear main bolt. Don’t forget to tighten the front one as well.
- Page 7 If the EV4 does not start please check if all cables were properly connected. Wires that haven’t a number attached to them don’t need to be connected to anything. If the vehicle still does not start please refer to...
Need help?
Do you have a question about the City Quad and is the answer not in the manual?
Questions and answers