Service Station Procedures
GRIP
SUPPORT ROD
CLIP
3. Holding the grip, pull the support
rod out of its clip. Insert the end
into the designated hole in the
hood.
356
To close the hood, lift it up slightly to
remove the support rod from the
hole. Put the support rod back into
its holding clip. Lower the hood to
about a foot (30 cm) above the
fender, then let it drop. Make sure it
is securely latched.
2011 RDX
Oil Check
Park the vehicle on a level surface.
Wait a few minutes after turning the
engine off before you check the oil.
1. Remove the dipstick (orange loop).
2. Wipe off the dipstick with a clean
cloth or paper towel.
3. Hold the dipstick with a clean
cloth or paper towel, and then
insert it all the way back in its
hole.
DIPSTICK