Honda GX160UT2 Manual page 54

62Z4H000.book 9 ページ ２０１１年５月２０日 金曜日 午前１０時５分
dummyhead dummyhead
OIL BATH TYPE
Remove the following:
– Wing nut [1]
– Air cleaner cap [2]
– Air cleaner cover [3]
– Air cleaner element [4]
Carefully check the element for holes or tears and
replace if damaged.
Clean the element if it is to be reused (page 3-9).
Check the oil contamination and oil level of the cleaner
oil pan [5].
If the oil level is low, fill with the recommended oil to the
upper level [6] of the cleaner oil pan.
If the oil is dirty, clean the cleaner oil pan and add the
recommended oil to the upper level of the cleaner oil
pan.
OIL CAPACITY: 60 cc
Installation is in the reverse order of removal.
SEMI DRY TYPE
Remove the following:
– Wing nut [1]
– Air cleaner cap [2]
– Air cleaner cover [3]
– Air cleaner element [4]
Carefully check the element for holes or tears and
replace if damaged.
Clean the element if it is to be reused (page 3-9).
Installation is in the reverse order of removal.
ELEMENT CLEANING
FOAM
Clean the filter [1] in warm soapy water, rinse, and allow
to dry thoroughly, or clean with a non-flammable
solvent and allow to dry thoroughly.
Dip the filter in clean engine oil, and squeeze out all the
excess oil.
Excess oil will restrict air flow through the foam element
and may cause the engine to smoke at startup.
MAINTENANCE
[3] [2]
[5]
[3] [2]
[1] Wash
Squeeze
and dry
Squeeze thoroughly
[1]
[4]
[6]
[1]
[4]
Dip
3-9