Replacing The Cover - Wickes Aquatronic 4 Ultra Installation And Operating Instructions Manual

Fig.
Valve
spindle
T00390
Fig.9
Temperature control set
at minimum flow setting
Aquatronic 4 Ultra electric shower
>POM-GF30<

REPLACING THE COVER

Replacing the cover
ImporTAnT: Before finally fitting the cover,
the following steps must be taken:
a. check the plumbing connections are
watertight.
b. check the terminal block screws are fully
tightened.
c. make sure the pipe and cable entering
the unit do not prevent the cover locating
correctly to the backplate.
d. Rotate the valve spindle fully clockwise
until the spindle hits the 'stop' (fig.).
Do NoT force the spindle.
e. Turn the temperature control on the
cover fully clockwise to the minimum flow
position (fig.9).
Offer the cover to the unit.
Carefully locate the cover tags into the guide
pockets on the backplate and make sure the
wires are not trapped.
Guide the cover into position so that the knob
spindle locates correctly (minor adjustment may
be necessary to align the knob and spindle).
Should any difficulty arise, recheck the points
above.
While applying slight pressure to the front cover,
secure in place using the three retaining screws.