Using Magic Watch - Waeco MAGIC WATCH MWE-150-2DIS Installation And Operating Manual

MWE-150-2DIS.book Seite 44 Mittwoch, 29. Juni 2005 5:20 17

Using MAGIC WATCH

8 Using MAGIC WATCH
MAGIC WATCH is activated automatically when you engage reverse gear
with the ignition on or the motor running.
As soon as there is an obstacle within the detection range, a repeated signal
tone sounds. At the same time, the display shows where the obstacle is: the
right LED lights up if the right side of the vehicle approaches an obstacle. If
the left side of the vehicle is approaching an obstacle, the left LED lights up.
As you reverse, the sequence of beeps changes according to the zone you
are in (see "Testing functions" chapter on page 43), thus indicating the dis-
tance. The numerical display shows the measured distance to the obstacle.
Be very careful the first time you use the system, until you are familiar with
the various sequences of beeps.
Caution!
Stop the vehicle immediately and check the situation (getting out if
necessary), if the following happens while you are reversing:
The device first shows an obstacle while you reverse, and the
beeps speed up as normal (i.e. from slow to medium). Suddenly
the beeps become slow again or no obstacle at all is shown.
This means that the original obstacle is in the blind spot of the sen-
sors (depending on the design), and you might hit it.
44
magic watch