Malfunction Indicator Light; Air Bag Light - Suzuki SX4/SX4 SEDAN Owner's Manual

INSTRUMENT PANEL
driver's seat belt is buckled. After repeating
several times, the reminder will be can-
celed even if the driver's seat belt remains
unbuckled.
For details about the seat belt reminder,
refer to "Seat Belts and Child Restraint
Systems" in the "BEFORE DRIVING" sec-
tion.
WARNING
It is absolutely essential that the
driver and passengers wear their seat
belts at all times. Persons who are
not wearing seat belts have a much
greater risk of injury if an accident
occurs. Make a regular habit of buck-
ling your seat belt before putting the
key in the ignition.

AIR BAG Light

This light monitors inflators, crash sensors,
seat belt pretensioners, the front passen-
ger sensing system, and corresponding
electrical circuits.
This light blinks for several seconds when
the ignition switch is turned to the "ON"
4-7
position so you can check if the light is
working. The light will come on and stay on
if there is a problem in the air bag system
or the seat belt pretensioner system.
WARNING
If the AIR BAG light does not blink
when the ignition switch is turned to
the "ON" position or stays on or
comes on when driving, the air bag
system or the seat belt pretensioner
system may not work properly. Have
both systems inspected by an autho-
rized SUZUKI dealer.

Malfunction Indicator Light

Your vehicle has a computer-controlled
emission control system. A malfunction
indicator light is provided on the instrument
panel to indicate when it is necessary to
63J030
have the emission control system serviced.
The malfunction indicator light comes on
when the ignition switch is turned to the
"ON" position to let you know the light is
working and goes out when the engine is
started.
If the malfunction indicator light comes on
or blinks when the engine is running, ser-
vice to the emission control system is nec-
essary. Bring the vehicle to your SUZUKI
dealer to have the emission control system
serviced right away and avoid hard accel-
eration until the service is performed.
CAUTION
Continuing to drive the vehicle when
the malfunction indicator light is on
or blinking can cause permanent
damage to the vehicle's emission
control system, and can affect fuel
economy and driveability.
NOTE:
If the fuel filler cap is not installed fully, the
electrical system gets wet (such as by driv-
ing through a deep puddle of water) or the
fuel tank gets nearly empty, the malfunc-
tion indicator light may come on. If so, the
light will go off after driving a few times
after the fuel filler cap is installed fully, the
65D530
electrical system dries out or the fuel tank
is filled.