Get Started; Prepare Telescopic Antenna; Connect Power; Adjust Display Brightness - Philips TAVS700 User Manual

3 Get started

Caution
• Use of controls or adjustments or performance
of procedures other than those specified herein
may result in hazardous radiation.
Always follow the instructions in this chapter
in sequence.
If you contact Philips, you will be asked for the
model and serial number of this speaker. The
model number and serial number are on the
back of the speaker. Write the numbers here:
Model No. ________________________
Serial No. ________________________

Prepare telescopic antenna

For optimal reception, fully extend and adjust
the direction of the telescopic antenna.
Tip
• Position the antenna as far away as possible
from your TV or other radiation source to
prevent interference.

Connect power

Caution
• Risk of product damage! Make sure that the
power supply voltage corresponds to the
voltage on the back or the underside of the
product.
• Risk of electric shock! When you unplug the AC
power cord, always pull the plug from the
socket. Never pull the cord.
• Use only the AC power cord specified by the
manufacturer or sold with this speaker.
Note
• The type plate is located on the back of the
speaker.
6 EN
Connect the AC ~ socket on the speaker and
the power socket on the wall with the AC
power cord.

Adjust display brightness

1
In standby mode, press and hold the small
knob on the right side for 2 second or more
to display the menu.
2
Rotate the big knob on the right side to
select the menu "DIM".
3
Press the small knob on the right side to
confirm your select.
4
Rotate the big knob on the right side to
select different levels of display brightness.

Set the Clock

1
In standby mode, press and hold the small
knob on the right side for 2 second or more
to display the menu "CLOCK".
2
Press the small knob on the right side to
confirm to activate the clock setting
the time format
[12H] or [24H]
blink
.
3
Rotate the big knob on the right side to
select [12H] or [24H].
4
Press the small knob on the right side to
confirm, the hour digits begin to blink.
5
Repeat above steps 3-4 to set the hour and
minute.
Note
• If no button is pressed in 10 seconds, the
speaker exits clock setting mode automatically.
mode,
begins to