Important safety instructions Please read all instructions carefully. Please keep these instructions for future reference. Heed all warnings. Follow all instructions. Do not use this apparatus near water. Clean only with clean dry cloth. Do not block any ventilation openings. Install in accordance with the manufacturers instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
Page 3
Important information on charging and using rechargeable batteries Recharge the batteries in any case at least every 2 months. Make sure the Battery Select switch inside the battery compartment is set to the “NiMH” position. Put the batteries in the compartment while paying attention to the correct polarity of the batteries (+ and -). First use: Charge new batteries in one continuous, uninterrupted, charge until they are full.
Make sure all batteries are inserted with correct polarity as shown in the battery compartment. Replace the battery cover. IMPORTANT When using alkaline batteries the battery switch must be placed in the alkaline position. Failure to do so could result in serious damage to the batteries or radio. Reduced power, distortion, “stuttering sound”...
Setting clock time Upon initial use of the radio after the batteries have been installed or the AC adaptor is plugged in, the display will flash . Rotate the Tuning control knob to set the required hours. Press the Select button. The minute digits will flash.
Page 8
Presetting stations – FM / AM The radio has 20 memory presets each for FM and AM radio. With your radio switched on, press the Source button to select the desired waveband. Tune to the required radio station as previously described. To store the FM / AM station as a preset, press the Page button to select the required preset page 1 to 4 and then press and hold the required preset button (1-5) until you hear a beep and the display will show the page and the memory pre-set you selected.
When the alarm sounds To cancel a sounding alarm, press the Power button. When the buzzer alarm activates, the buzzer alarm symbol will flash on the display. The alarm will start softly and gradually increase in level (Humane Wake System). It will sound for 1 minute and silence for 1 minute in repetition for 60 minutes unless cancelled.
Bluetooth device can pair or link with your radio. ● If ‘PR-D12BT’ shows in your Bluetooth device list but your device cannot connect with it, please delete the item from your list and pair the device with the radio again following the steps described previously.
Bluetooth source device in memorywhich is last connected. If the last connected Bluetooth source device is not available, the PR-D12BT will try to connect to the second last Bluetooth source device.
Specifications AC Power adaptor DC 9V 0.7A center pin positive Batteries 4 X LR6 (AA size) Approx. 35hours of listening with the speaker at normal volume level. Battery Life Approx. 80hours of listening with headphones at normal volume level. Rechargeable battery charging time approx.