How To Use - Black & Decker 220UH Use & Care Book

220UHPub1000002304 5/6/05 11:17 AM
Product may vary slightly from what is illustrated.
1. Fold-down handle
2. Timer knob
3. Control knob
4. CAUTION indicator
5. Heat sensor patch
6. Front grille
7. Roll-over bars
8. Power indicator
9. Thermostat control
RESET
To restore power, you MUST press the RESET button on the line
cord protection safety device to reactivate the circuit.
A
Page 4
TEST
3

How to Use

This appliance is intended for household use only.
Important: For warranty verification, do not remove line cord sticker.
The Advanced Safety Technology™ (AST) system features unique technology built
into your heater that offers protection detailed in the "Special Features" section.
Included in AST is a shock protection device built into the line cord and equipped
with a test button to check operation:
Before Use:
1. Press RESET button on line cord safety device (A).
2. Plug into a regular AC electrical outlet.
3. Press TEST button and RESET button will pop out (see A) to show safety device
is operating properly. Repeat this procedure each time you use heater to
confirm safety device is operational. Should RESET button not pop out, do not
use heater. Call appropriate "800" number on the cover of this book.
At any time, should this unit detect an electrical shock hazard, it will immediately
shut off. To restore power, you must press RESET button on the line cord
protection safety device to reactivate circuit.
Important:
During the first few minutes of initial use, you may notice a slight odor. This is
normal and will quickly disappear. This heater is intended for use on a flat, stable
surface, such as a floor, tabletop, shelf, or desk in a location where the airflow
grille openings won't be obstructed. Do not use in wet or moist locations, like
bathrooms or laundry areas, or in areas where paint or other flammable or volatile
liquids are used or stored.
Caution: Be sure no other appliances are plugged into same circuit with
heater/fan. A circuit overload could occur.
1. Place heater on a flat, stable surface, such as a floor or tabletop where airflow
grille opening won't be obstructed. Use fold-down handle when moving unit.
Do not use in wet/moist locations, like bathrooms or laundry areas, or in areas
where paint, flammable, or other volatile liquids are used or stored.
2. Be sure control knob is in the OFF position, then plug heater into a standard
AC outlet.
3. Room Select™ Control: Turn switch to the appropriate
setting for a small (approx. 10' x 10'/3 m x 3 m),
medium (approx. 12'x12'/3.8 m x 3.8 m) or large
(approx. 12'x 16'/3.8m x 5m) room (B).
4. Turn thermostat control to HOT to activate heater. Once
desired room temperature is achieved, lower thermostat
B
control toward FROST WATCH until unit cycles off.
The thermostat will cycle unit on and off to maintain your comfortable
temperature level.
5. Turn timer knob to the 1 hr., 2 hr., 3 hr. or 4 hr. setting to select how long
you'd like heater to stay on. The unit will shut off automatically once the
selected time runs out. To operate heater continuously, turn timer knob to ON.
Remember to shut unit Off when done.
6. To use as a fan without heat, move control knob to FAN ONLY and thermostat
control toward HOT until fan begins to operate. No heating will occur in
this mode.
4