Device Management; Connecting To The Device - Siemens RUGGEDCOM RSG920P Installation Manual

RUGGEDCOM RSG920P
Installation Guide

Device Management

This section describes how to connect to and manage the device.
CONTENTS
• Section 3.1, "Connecting to the Device"
• Section 3.2, "Configuring the Device"
• Section 3.3, "Inserting/Removing the MicroSD Card"
Section 3.1

Connecting to the Device

The following describes the various methods for accessing the RUGGEDCOM ROS console and Web interfaces
on the device. For more detailed instructions, refer to the RUGGEDCOM ROS User Guide for the RUGGEDCOM
RSG920P.
RS-232 Console Port
Connect a workstation directly to either the RJ45 or USB Type-B console port to access the boot-time control
and RUGGEDCOM ROS interfaces. Both console ports provide access to RUGGEDCOM ROS's console and Web
interfaces.
IMPORTANT!
Console ports are intended to be used only as a temporary connection during initial configuration or
troubleshooting.
NOTE
When the USB Type-B console port is in use, the RJ45 console port will echo the console output but not
accept any user input.
NOTE
For Microsoft Windows users, the RUGGEDCOM USB Serial Console driver must be installed on the users
workstation before connecting via the USB Type-B console port. For more information, refer to the
RUGGEDCOM ROS User Guide for the RUGGEDCOM RSG920P.
Connecting to the Device
Chapter 3
Device Management
19