Required Tools And Materials - Siemens RUGGEDCOM RSG920P Installation Manual

RUGGEDCOM RSG920P
Installation Guide
POWER LED
ALARM LED
Port Status LEDs
Access Plate
Digital Inputs
Failsafe Alarm Relay
Power Supply Terminal Block
Section 1.3

Required Tools and Materials

The following tools and materials are required to install the RUGGEDCOM RSG920P:
RUGGEDCOM RPS1300 or equivalent 54 VDC output power supply
AC or DC power cord (16 AWG)
CAT-5 Ethernet cables
Flathead screwdriver
Phillips screwdriver
4 x #8-32 screws
Required Tools and Materials
Illuminates when power is being supplied to the device.
Green
Red
Off
Illuminates when an alarm condition exists.
Indicate the status of each port. For more information, refer to
Ports.
The removable access plate provides access to the USB Type-B console port and microSD slot.
• Use the USB console port to connect directly to the USB port on a workstation. For more
information about the USB console port, refer to
• Use a microSD card to load/store the firmware and configuration for the device. For
information about using a microSD card, refer to
MicroSD
Two isolated independent digital inputs to monitor external equipment, such as a
passive switch or voltage provided by external equipment. For more information, refer to
Section 2.7, "Connecting the Digital
Latches to default state when a power disruption or other alarm condition occurs. For more
information, refer to:
• Section 2.6, "Connecting the Failsafe Alarm Relay"
• Section 5.3, "Failsafe Alarm Relay Specifications"
A pluggable terminal block. For more information, refer to:
• Section 2.8, "Connecting Power"
• Section 5.1, "Power Supply Specifications"
Tools/Materials
Color
Card".
Inputs".
For supplying PoE power to the device.
For connecting power to the device.
For connecting the device to the network.
For mounting the device to a DIN rail.
For mounting the device to a panel.
For mounting the device to a panel.
Description
Device ready
Device booting up
No power
Chapter 4, Communication
Section 3.1, "Connecting to the
Section 3.3, "Inserting/Removing the
Purpose
Chapter 1
Introduction
Device".
3