Download  Print this page

Display Mode; Using Auto-sleep Mode - HP 25x User Manual

Hide thumbs

Advertisement

Display Mode

The display mode of the monitor is reported in the monitor status message that appears when the monitor is
turned on and when the video input is changed. The current display mode is shown in the Information menu
window and at the bottom of the OSD's main menu in the status bar area. Modes of operation are Normal and
Adaptive-Sync.
To turn on the Adaptive-Sync mode:
1.
Press the center of the OSD joystick to open the OSD.
2.
In the OSD select Gaming.
3.
Select Adaptive-Sync, and then select On.
NOTE:
The Adaptive-Sync menu default setting is On.

Using Auto-Sleep Mode

The monitor supports an OSD menu option called Auto-Sleep Mode that allows you to enable or disable a
reduced power state for the monitor. When Auto-Sleep Mode is enabled (enabled by default), the monitor
enters a reduced power state when the computer signals low power mode (absence of either horizontal or
vertical sync signal).
Upon entering this reduced power state (sleep mode), the monitor screen is blanked, the backlight is turned
off, and the power light turns amber. The monitor draws less than 0.5 W of power when in this reduced power
state. The monitor wakes from sleep mode when the computer sends an active signal to the monitor (for
example, if you activate the mouse or keyboard).
To disable Auto-Sleep Mode in the OSD:
1.
Press the center of the OSD joystick to open the OSD.
2.
In the OSD, select Power.
3.
Select Auto-Sleep Mode, and then select Off.
14
Chapter 2 Using the monitor

Advertisement

Table of Contents

   Related Manuals for HP 25x

Comments to this Manuals

Symbols: 0
Latest comments: