Table of Contents
Advertisement
Epson Research and Development
Vancouver Design Center
3 Installation and Configuration
The S5U13743P00C100 evaluation board incorporates a DIP switch, jumpers, and 0 ohm
resistors which allow it to be used with a variety of different configurations.
3.1 Configuration DIP Switch
The S1D13743 has 3 configuration inputs (CNF[2:0]). A DIP switch (SW1) is used to
configure CNF[2:0] as described below.
SDU13743P00C100
SW1-[4:1] Config
CNF[2:0] Config
SW1-[1]
SW1-[2]
SW1-[3]
SW1-[4]
= Required settings when using S5U13U00P00C100 USB Adapter board
The following figure shows the location of DIP switch SW1 on the S5U13743P00C100
board.
DIP Switch
SW1
S5U13743P00C100 Evaluation Board User Manual
Issue Date: 2007/08/15
Table 3-1: Summary of Power-On/Reset Options
S1D13743
CNF0
Host Data lines are normal
CNF1
Host Data is 16-bit
CNF2
PIOVDD output current = 6.5mA
-
not used
Figure 3-1: Configuration DIP Switch (SW1) Location
Power-On/Reset State
1 (ON)
Host data lines are swapped
Host data is 8-bit
PIOVDD output current = 2.5mA
Revision 1.0
Page 7
0 (OFF)
S1D13743
X70A-G-001-01
Advertisement
Table of Contents
