Installation Instructions; Unpacking; Install The Leveling Legs (Optional); Door Closing - KitchenAid KRCA06XPSS00 Use & Care Manual

Unpacking

WARNING
Excessive Weight Hazard
Use two or more people to move and install
refrigerator.
Failure to do so can result in back or other injury.
Removing packaging materials
Using a ³⁄₈" wrench, remove skids from the bottom of the
refrigerator and properly discard the attachment bolts.
Remove tape and glue residue from surfaces before turning
on the refrigerator. Rub a small amount of liquid dish soap
over the adhesive with your fingers. Wipe with warm water
and dry.
Do not use sharp instruments, rubbing alcohol, flammable
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your refrigerator. For
more information, see the "Refrigerator Safety" section.
Dispose of all packaging materials properly.
When Moving Your Refrigerator:
Your refrigerator is heavy. When moving the refrigerator
for cleaning or service, be sure to protect the floor.
Always pull the refrigerator straight out when moving it.
Do not wiggle or "walk" the refrigerator when trying to move
it, as floor damage could occur.
Clean Before Using
After you remove all of the packaging materials, clean the inside
of your refrigerator before using it. See the cleaning instructions
in the "Refrigerator Care" section.

Install the Leveling Legs (optional)

WARNING
Excessive Weight Hazard
Use two or more people to move and install
refrigerator.
Failure to do so can result in back or other injury.
IMPORTANT:
Always lay the refrigerator on its left side during the leveling
leg installation. If you lay the refrigerator on its back, you can
damage the refrigerator.
Never place refrigerator on its top. It may damage the
compressor.

INSTALLATION INSTRUCTIONS

Allow the refrigerator to sit upright for 4 hours before plugging
into an electrical outlet.
1. Using 2 or more people, lay the refrigerator on its side.
2. Screw two leveling legs into the bottom of the refrigerator at
the front.
3. Screw two leveling legs into the bottom of the refrigerator at
the rear.
4. Move the refrigerator to its final location.
5. Lower the front legs just enough to lift the cabinet up off of
the floor.
6. Adjust the legs to level the refrigerator:
Turn the leveling leg to the right to lower that side of the
refrigerator.
Turn the leveling leg to the left to raise that side of the
refrigerator.

Door Closing

NOTE: You can install either the leveling legs or the casters on
your refrigerator. Shims can be placed under the casters to level
a refrigerator that has casters installed.
Door Closing
Your refrigerator has four leveling legs. If your refrigerator seems
unsteady or you want the door to close more easily, adjust the
refrigerator tilt using the instructions below:
1. Plug into a grounded 3 prong outlet.
2. Move the refrigerator into its final location.
3. Turn the leveling leg to the right to lower that side of the
refrigerator or turn the leveling leg to the left to raise that side.
It may take several turns of the leveling leg to adjust the tilt of
the refrigerator.
5