Enter the password (the password is
noted in the Service Guide).
Select Exit until the Operating Mode
task window disappears from the
Press Main Screen on the front
panel of the monitor.
How do I leave
When Configuration Mode is activated, the following message appears
at the top of the screen:
– Config (which alternates with)
– to exit: cycle power
When you have finished adjusting the settings and you want to make
your changes permanent, they must be stored in one of the available
QuickSets (see "Saving current settings to a Quick Set" on page 356).
If you exit the configuration mode before storing your changed settings
in a QuickSet, the changes will be lost.
Before leaving Configuration Mode, make sure you have stored all the
To leave Configuration Mode you can either:
– Switch the monitor off and back on again,
A set of keys will open at the bottom
of the screen for the password.
Use the keys labelled 1 to 5. If the
password is correct, Config will be
marked with a * in the Operating
Modes task window.