Operating Your Cafe Juice - Sunbeam Cafe Juice JE7600 Instruction Booklet

Operating your Sunbeam
Cafe Juice
Note: The Cafe Juice™ should be completely
assembled before use, if this is not the case
see 'Assembling your Sunbeam Cafe Juice™
on page 7.
1.Ensure the control switch on the juicer is
in the 'Off' position and insert the power
cord into a 230-240V AC power outlet and
turn the power 'On'.
2.Clean fruit and vegetables thoroughly,
ready for juicing.
Note: The extra large feed chute allows
whole fruit and vegetables to be juiced,
however some fruit and vegetables may
require other preparation before juicing,
such as peeling and removing stones, see
'Juicing speed guide' on page 10 for our
recommendations.
3.Ensure that the juicer has been assembled
completely and correctly, making sure
that the stainless steel blade and filtering
basket revolves properly before placing fruit
and vegetables in the juicer.
Note: The stainless steel blade and filtering
basket should be cleaned thoroughly before
each use, see 'Care and cleaning' on page
12.
4.Place a jug or glass under the juice spout.
5.Select 'Low' or 'High' speed with the control
switch. To select 'Low' speed push the
control switch down. To select 'High' speed
push the control switch up.
For optimum juicing results 'Low' speed is
used primarily for soft fruit and vegetables,
particularly those with a high water content
and 'High' speed is ideal for hard and
fibrous fruit and vegetables. A list of fruit
and vegetables commonly used for juicing
and their recommended juicing speed are
specified in the 'Juicing speed guide' on
page 10.
™
Important: Do not operate for more than
20 seconds at a time when juicing heavy
loads. None of the recipes in this manual
are considered a heavy load.
6.With the juicer in operation, place the
fruit and vegetables into the feed chute.
Using the food pusher, guide the fruit and
vegetables down the feed chute and onto
the stainless steel blade.
Tip: For maximum juice extraction, guide
the food pusher down the feed chute in a
slow downward motion.
Important: Do not push fruit or vegetables
into the feed chute with your fingers,
always use the food pusher provided.
7.The juice from the fruit and vegetables will
flow directly into the jug or glass and the
pulp will be separated and collected in the
pulp container.
Important: When juicing be aware of
the level of pulp in the pulp collection
container, because if the container is
overfilled this can cause damage to the
appliance and prevent the juicer from
operating correctly.
8.When juicing is complete ensure that the
juicer is switched 'Off' and unplugged from
the power outlet.
9