Capacity Rating/Draw Stud Selection - Greenlee 1904Pg Instruction Manual

IMPORTANT SAFETY INFORMATION
Set up the tool properly. An improper setup could
cause a component to fail and strike nearby
personnel with great force.
• Thread the punch completely onto the draw stud.
All of the punch threads must be engaged by the
draw stud threads. Incomplete assembly could
cause a component failure.
• Use only Greenlee punches, dies and draw
studs. Other manufacturers' components might
not withstand the forces generated by this punch
driver.
Failure to observe these warnings can result in
severe injury or death.
Do not exceed the rated capacity of this tool.
Exceeding the rated capacity could cause a
component failure, which could throw broken parts
with great force.
Failure to observe this warning can result in severe
injury or death.
1904 with Slug-Splitter, Slug-Buster, or standard Greenlee punches and dies
MATERIAL
THICKNESS
10 GAUGE
12 GAUGE
14 GAUGE
16 GAUGE
Standard and Slug-Buster Greenlee punches
DRAW STUD NO.
12097
30227
12099
Greenlee Textron / Subsidiary of Textron Inc.
High Capacity Ratchet Knockout Drivers
CAPACITY RATING
FREQUENT
USE
MILD STEEL
CONDUIT SIZE
1/2 3/4 1 1-1/4 1-1/2
DRAW STUD SELECTION
CONDUIT SIZE
1/2 3/4 1 1-1/4 1-1/2
• Do not add extensions (cheaters) to the handles.
When punching at maximum capacity, this tool
requires approximately 80 pounds of handle force.
Using excessive force can damage the punch
driver.
• Do not drive the ratchet after spindle motion stops.
Driving the ratchet after the spindle motion stops
can damage the punch driver.
Use this tool for the manufacturer's intended
purpose only. Any other use can result in injury or
property damage.
Note: Keep all decals clean and legible, and replace
when necessary.
MAXIMUM
CAPACITY
1904 with Slug-Splitter punches only
STAINLESS STEEL
2 2-1/2 3 1/2 3/4
Slug-Splitter punches
2 2-1/2 3 1/2 3/4
4
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815/397-7070
CONDUIT SIZE
1 1-1/4 1-1/2 2
CONDUIT SIZE
1 1-1/4 1-1/2 2