Table of Contents
Advertisement
Installing the unit
1) Place the pattern sheet on the ceiling at the spot where you want to
install the indoor unit.
• Since the diagram is made of paper, it may shrink or stretch slightly
holes maintain the correct dimensions between the markings.
2) Insert bolt anchors, use existing ceiling supports or construct a
weight of the indoor unit. Before hanging the unit, test the
strength of each attached suspension bolt.
• If this is not possible, create an opening on the false
operations on the indoor unit.
•
4. Cautions about HR Changer installation.
16
English
Hole in anchor
Hole in plug
Unit : mm (inch)
Anti vibration
rubber
<Fixing the bolt>
Concrete
Insert
Ceiling support
Nut
Washer
Hide quick links:
Advertisement
Table of Contents
