Assemble the injection pump.
8 mm
nut
. . . . . . . . . . . . . . .
3 pcs.
Spring washer
. . . . . . . . . . . .
3 pcs.
NOTE:
Measure the distance between the face of the cam base and the surface to which the injection pump is to be
fitted. And adjust
it
may become
76
k
0.05
mm, using the shims. Two kinds of t h e shim are available, viz. 0.1 mm, and
0.3
mm.
CAUTION: Remove the oil filler cap and check if the control rack comes off from the governor lever.
(See Figs.
44
and
45
.)
-
. .-
l . _ l
___
"
I
~
. "
,
,
-
Fig.
45
Assembe the tappet guide.
CAUTION: Be careful not l e t the tappet fall i n
case.
NOTE:
The roll pin of the tappet guide is to be
a t the right side as viewed from the gear case side.
(See Fig. 46.)
the
set
Fig.
46
13) Temporarily assemble the push rod sleeve.
6 mm nut
. . . . . . . . . . . . . . .
2 pcs.
Spring washer
. . . . . . . . . . . .
2 pcs.
NOTE:
2
pcs.
of the plate (push rod sleeve) are to be assembled temporarily.
-
24
-