Download Print this page

Black & Decker SSL16 Instruction Manual page 5

16v & 20v max* cordless drills
Hide thumbs

Advertisement

90565382 SSL16 SSL20 NEW Smart Select.qxd:??????-00 BDL500 laser
pack after use, avoid placing the charger or battery pack in a warm environment such as
in a metal shed, or an uninsulated trailer.
3. If the battery pack does not charge properly:
a. Check current at receptacle by plugging in a lamp or other appliance
b. Check to see if receptacle is connected to a light switch which turns power off
when you turn out the lights.
c. Move charger and battery pack to a location where the surrounding air
temperature is approximately 65°F - 75°F (18°- 24°C).
d. If charging problems persist, take the tool, battery pack and charger to your
local service center.
4. The battery pack should be recharged when it fails to produce sufficient power on
jobs which were easily done previously. DO NOT CONTINUE to use under these
conditions. Follow the charging procedure. You may also charge a partially used pack
whenever you desire with no adverse affect on the battery pack.
5. Foreign materials of a conductive nature such as, but not limited to, steel wool,
aluminum foil, or any buildup of metallic particles should be kept away from charger
cavities. Always unplug the charger from the power supply when there is no battery
pack in the cavity. Unplug charger before attempting to clean.
6. Do not freeze or immerse charger in water or any other liquid.
Shock hazard. Do not allow any liquid to get inside charger.
TO INSTALL BATTERY PACK: Insert battery
pack into tool until an audible click is heard
as shown in figure B.
TO REMOVE BATTERY PACK: Depress the
battery release button as shown in figure C
and pull battery pack out of tool.
6/3/10
1:40 PM
Page 8
3
ON-PRODUCT
IMAGE
2
1
APPLICATION
DRILL AUTOMATICALLY DELIVERS
Driving 1/4 in.-1 in. screws
LOW TORQUE
Driving 1 in. or longer screws
MEDIUM TORQUE
Drilling 5/16-1/2 in. into metal
HIGH TORQUE
HIGHEST TORQUE
Driving 1 in. or larger spade bit
Transition from
SHIFT
HIGH TORQUE to HIGH SPEED
Drilling up to 1/2 in. drill bit
HIGH SPEED
into any material
Drilling 1/8 in.-1/4 in. into metal
HIGH SPEED
Driving 7/8 in.-1 in. spade or
HIGH SPEED
smaller bit into wood

Advertisement

loading

  Also See for Black & Decker SSL16

This manual is also suitable for:

Ssl20