Subscribe to Our Youtube Channel
Related Manuals for Strong Pools and Spas Monaco
Summary of Contents for Strong Pools and Spas Monaco
- Page 1 OWNER’S MANUAL ™ 3204 Point Township Drive (Rte 11) • P.O. Box 108 Northumberland, PA 17857 1-800-STRONG-9 1-800-787-6649 1/8/07...
-
Page 2: Table Of Contents
Please fill it out and send it to Strong Pools and Spas immediately. Failure to return the registration card and a photocopy of the sales receipt within Registration Form 30 days of purchase voids all warranties provided by Strong Pools and Spas 7 - 9 10-11... -
Page 3: Introduction
With proper care, operation and maintenance, your spa will provide your family many years of comfort and pleasure. Please take time to read all the instructions before you install your Strong Pools & Spa, "Monaco" spa. This manual explains safety precautions, installation instructions, operating directions and maintenance procedures. -
Page 4: Health Safety
Health Safety Spas are known for their helpful qualities such as hydrotherapy and arthritic relief. But spas are not only a toy, there are several health concerns which the owner must be aware of such as the following: WARNING People with infectious diseases should not use a spa. The use of alcohol, drugs or medication before or during spa use may lead to uncon- sciousness with the possibility of drowning. -
Page 5: Installation -Spa Placement
Installation - Spa placement Spa Location: Improper installation may result in equipment damage and will void the warranty. Your spa must be placed on a flat, level surface. The space you choose to install your spa is a very important decision, you should consider all of the listed suggestions. -
Page 6: Electrical - General
Connections should be made using copper conductors only. The connecting wire and circuit breakers or fuses must be sized to accommodate the total ampere load as specified on the equipment module data label. Strong Pools and Spas only makes electrical recommendations, always consult a certified electrician. TERMINAL BLOCK... -
Page 7: Control Panel Identification
Control Panel Identification Blower This key is not used to activate any operation in Strong Spas. Jets Touch the “Jets” button once to activate the low speed of the pump and again for the high speed. Press the “Jets button again to turn off the pump. If left run- ning, the low speed of the pump will automatically turn off after 4 hours, and the high speed will automatically turn off after 15 minutes. -
Page 8: Startup Preparations
Startup Preparations - Make sure that if spa is equipped with gate valves, that valves are opened. (These gate valves are easily noticed in your access area by the distinct “T” shaped handle.) - When filling your spa remove the filter, and place hose into filter area.This will fill the plumb- ing first, and hopefully reduce the chance of air lock. -
Page 9: Changing Filter Cycles
Changing Filter Cycles FILTRATION Proper filtration is an important key to maintaining the clarity of your spa's water. The filter system is designed for unsurpassed effectiveness at removing debris and suspensions from the water anytime the water is circulating. Your control panel is set to filter for two hours every twelve hours. A two speed pump is supplied with your spa that provides filtration on low speed, the low speed will shut off if the temperature creeps more than 2 degrees above the set point, it will turn back on when temperature drops to the set point. - Page 10 Troubleshooting Problem: No message on display. Power has been cut off to spa. Solution: The control panel will be disabled until power returns. Spa settings will be preserved until next power up. Problem: Temperature unknown. Solution: After the pump has been running for 2 minutes, the temperature will be displayed. Problem: “Overheat”...
-
Page 11: Freeze Protection
Troubleshooting Problem: A significant difference between temperature sensors has been detected. This could indicate a flow problem. Solution: Check water level in spa. Refill if necessary. If water level is okay, make sure the pumps have been primed. If problem persists, contact your dealer or service organiza- tion. -
Page 12: Spa Maintenance
Spa Maintenance The maintenance and care of your spa is simple and easy to carry out, and if performed regularly as scheduled, problems will be minimal. It is important that the following proce- dures be read through and carried out on a regular basis for the best, long term, overall performance of your spa. - Page 13 Spa Maintenance (continued) CONCENTRATED CHLORINATING GRANULES - The minimum chlorine level in the spa should be at least 2PPM (parts per million). Chlorine level should be tested frequently and the chemical added to maintain a safe level of 2PPM. This type of chemical can be added in quantities of 0.5 ounce per 500 gallons of spa water.
-
Page 14: Warranties
Spa Structure: 10 years Strong Spas warrants the original retail purchaser the structural integrity of the spa shell against water loss due to defects in material or workmanship for as long as the customer shall own the spa. (repair or replacement) Spa Surface: 7 years Strong Spas warrants the original retail purchaser the surface integrity of the spa against blistering or delaminating as a result of defects in material or workmanship for a period of 7 years. -
Page 15: Safety Precautions
30 days of purchase. Purchaser’s Name: Address: City, State, Zip: Telephone No.: Signature: Comments: 30 days of purchase voids all warranties provided by Strong Pools and Spas REGISTRATION CARD Purchase Date: Model Name: Serial Number: Dealer’s Name: Address:... - Page 16 RETAIN THIS BOOKLET FOR FUTURE REFERENCE: FOR ANY MISSING PARTS, PROBLEMS OR QUESTIONS CALL: MONDAY THROUGH FRIDAY 8:30 AM - 5:00 PM E.S.T. • GIVE YOUR NAME • TELEPHONE NUMBER (AREA CODE) • NAME OF SPA • NAME OF MODEL 3204 Point Township Drive (Rte.
Need help?
Do you have a question about the Monaco and is the answer not in the manual?
Questions and answers