Honeywell Miller QuickPick Rescue Kits User Instruction Manual page 8

Anchorage Requirements (continued)
point must be used, an anchorage connector should be selected such that the unit will be
within reach of the rescuer or an anchorage connector and pigtail must be installed to bring
the unit to the acceptable height above the rescuer.
The anchorage connector, if required to attach the QuickPick rescue device to the anchor
point, must be compatible with the anchorage and meet the above anchorage strength
requirements. In addition, the anchorage connector must be compatible with the carabiner
on the backup braking system (or pulley, if using the basic QuickPick kit) and must not
be capable of causing a load to be applied to the gate/keeper. Never use an anchorage
connector which will not allow the carabiner gate/keeper to close and lock.
Pre-Assembly and Inspection
Because time is critical in a rescue situation,
the QuickPick Rescue Kit must be maintained
and stored in a ready-to-use state--components
have been preassembled and inspected. The
QuickPick system is shipped from the manu-
facturer preassembled; however, it is always a
good practice to verify the preassembly and en-
sure that all components are securely fastened.
Refer to Figure 1 for the preassembled state.
For inspection procedures, refer to section
5.0 Inspection and Maintanence in this manual.
Once correct preassembly has been verified and
inspection is completed, return components to
their storage bags until needed for rescue.
Us er I ns t r u ct ion s - En gli sh
Preassembled
Premium System
8
Fig. 1
Preassembled
Standard System