Table of Contents
Advertisement
2. Press any button to stop the signal.
3. Turn off the oven.
To stop the cleaning before it finishes
turn the knob for the heating functions to
the off position.
4. When the oven cools down, clean the
cavity with a wet soft cloth.
Spots or discolouration of the catalytic
coating have no effect on Catalytic
cleaning.
11.4 Cleaning reminder
As a reminder that catalytic cleaning is
necessary, CATA flashes in the display
for 10 seconds after each activation and
deactivation of the oven.
The cleaning reminder goes out:
• after the end of the Catalysis function.
• if you press
and
time.
11.5 Removing and installing
the door
You can remove the door and the
internal glass panels to clean it. The
number of glass panels is different for
different models.
WARNING!
The door is heavy.
1. Open the door fully.
2. Fully press the clamping levers (A)
on the two door hinges.
A
3. Close the oven door to the first
opening position (approximately 70°
angle).
4. Hold the door with one hand on each
side and pull it away from the oven at
an upwards angle.
5. Put the door with the outer side down
on a soft cloth on a stable surface.
6. Hold the door trim (B) on the top
7. Pull the door trim to the front to
8. Hold the door glass panels on their
at the same
9. Clean the glass panel with water and
When the cleaning is completed, do the
above steps in the opposite sequence.
Install the smaller panel first, then the
larger and the door.
11.6 Replacing the lamp
A
1. Turn off the oven.
Wait until the oven is cooled down.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the
edge of the door at the two sides and
push inwards to release the clip seal.
2
B
remove it.
top edge one by one and pull them
up out of the guide.
soap. Dry the glass panel carefully.
WARNING!
Make sure that the glasses
are inserted in the correct
position otherwise the
surface of the door may
overheat.
WARNING!
Risk of electric shock.
The lamp can be hot.
cavity.
ENGLISH
31
1
Advertisement
Table of Contents
