Simrad EK80 Installation Manual page 186

Simrad EK80
Procedure
1 Connect the peripheral system to an available communication port on your Processor
Unit.
This is described in the Cable layout and interconnections chapter.
2 Click the
Operation
The icon is located under the
3 On the
Operation
Observe that the
selected by the menu on the left side.
4 On the left side on the
5 Set up the data export parameters.
a Select which data format to export.
b Click .
Add
Observe that a dedicated dialog box opens to collect the communication
parameters.
c Select which communication port to use.
d Click
Inspect Port
If you need to adjust the port settings, click
dialog box, and make the necessary changes to the communication port.
Outputs
You can do this after you have defined the output parameters.
e Click to save the chosen settings and close the dialog box.
OK
6 On the left side of the
Observe that the
7 On the
I/O Setup
8 If you are using a serial port, define the relevant communication parameters.
a Click
Setup
184
icon.
menu. It is used to open the
Main
menu, click .
Output
dialog box opens. This dialog box contains a number of pages
Output
dialog box, click
Outputs
to verify that the port parameters are correct.
dialog box, select
Outputs
page is shown.
I/O Setup
page, click once on the chosen communication port to select it.
to open the
Serial Port Setup
Operation
.
Relay Output
on the left menu in the
I/O Setup
.
I/O Setup
dialog box.
menu.
394149/C