Pairing The Wireless Subwoofer With The Soundbar - Hitachi AXS460BTU Instruction Manual

Pairing the Wireless Subwoofer with the Soundbar

Automatic Pairing
Plug the soundbar and the subwoofer into the mains sockets and switch on the subwoofer.
Press on the unit or on the remote control to switch the unit to On mode. The display will
show "WELCOME". Then the subwoofer and soundbar will automatically paired within 30
seconds.
Do not press PAIR on the rear of the subwoofer, except for manual pairing.
Manual Pairing
It is very abnormal that the connection would fail. You should not attempt manual pairing in normal
usage.
If the automatic pairing fails or the subwoofer is switched OFF
SUB" for 20 seconds. Ensure that all the cables are well connected, the main unit and the
subwoofer is switched to On mode. If it still doesn't work, pair the subwoofer with the
soundbar manually.
1. Unplug both units from the mains sockets, then plug them in again after 3 minutes.
2. Press on the unit or on remote control to switch the unit on.
3. Press and hold the PAIR button on the rear of the subwoofer, and then press and hold
SOURCE and VOL+ on the unit for a few seconds to start pairing. The pair indicator on
the subwoofer will rapidly blink when pairing and will become solid when successful.
4. While the unit is pairing with the subwoofer, "CNCT SUB
5. After the subwoofer is paired with the unit, "CNCT SUB" will disappear, and the display
will show the current channel.
After connecting the power, you must press PAIR
The subwoofer should be within 5 m of the soundbar in an open area.
interferences and repeat the above procedures.
ash on the display.
ict or strong interference (for example,
icts or strong
ash "CHK
ective.
19