Pronteau Produo PROBOIL.2 Installation Manual

PROBOIL.2
⚠
These instructions should be used in conjunction with the principal These instructions should be used in
These instructions should be used in These instructions should be used in
substitute the section referring to the installation of the 3in1 tap with this guide. substitute the section referring to the installation of the 3in1 tap with this guide.
substitute substitute the section referring to the installation of the 3in1 tap with this guide. the section referring to the installation of the 3in1 tap with this guide.

Important Technical Data

Important Technical Data Important Technical Data Important Technical Data
Minimum operating pressure (cold): 1.5 bar
Flow characteristics: Dual flow filtered water, Boiled water through centre insulated spout channel.
*If these pressures are exceeded, even for short periods, damage can result. In these instances a pressure reducing valve should be
installed.
This product is manufactured in accordance with recognised European standards. Please ensure that your product is fitted in
accordance with Local Water Byelaws. . . . A A A A su su su suitable non
non-return valve on the cold supply before 3 way tee (F1) is required (see instructions key).
These installation guidelines have been prepared for your direction and you must exercise due care at all times. We do not accept
responsibility for problems that may occur through improper installation. Whilst assembling the tap take care not to accidentally
loosen any factory fixed assemblies.
This tap has been 100% assembly tested; therefore you may expect a small residual amount of water to remain in the tap when
delivered. Any water marks can be removed using the supplied care advice.

Installation Preparation

Installation Preparation
Installation Preparation Installation Preparation
⚠
Before installing the new mixer it is essential that you thoroughly flush through the supply pipes in order to remove any
remaining solder, swarf or impurities from your system. Failure to carry out this simple procedure could cause problems or damage to
the workings of the dispenser or boiler.
We recommend installing particle filters (not shown) and an isolation valve to the cold feed pipe in an accessible position. This will
help to prevent premature failure of the valves and ease any future maintenance.
Ensure you have suitable domestic cold water pressure before installing this product (see technical data for more information Ensure you have suitable domestic cold water pressure before installing this product (see technical data for more information Ensure you have suitable domestic cold water pressure before installing this product (see technical data for more information). ). ). ). Ensure you have suitable domestic cold water pressure before installing this product (see technical data for more information
All parts should be removed from their packaging and inspected for any transport damage and that all parts are present prior to
installation.
Shut off your water supply system, ensure that your mains stopcock is closed. Open the lowest cold tap in the house and allow the
water to run until fully stopped.
If replacing an existing tap, remove the tap & clean the end of the feed pipes using wire wool, the tap hole area should be free from
dirt and sealant. Loosely position the tap and tail pipes to check if any alteration to the existing pipework is required. If this is the case
do this now.
If replacing an existing tap, remove the tap & clean the end of the feed pipes using wire wool,
the tap hole area should be free from dirt and sealant. Loosely position the tap and tail pipes to
check if any alteration to the existing pipework is required. If this is the case do this now.
This dispenser requires a Ø35mm tap hole.
This dispenser is designed to be installed in a worktop with a maximum thickness of 50mm.
2 Way Dispenser Installation Guide
conjunction with the principal instruction booklet suppl
conjunction with the principal conjunction with the principal
itable non- - - - return (check) valve itable non itable non return (check) valve should be installed to return (check) valve return (check) valve
instruction booklet supplied
instruction booklet suppl instruction booklet suppl
Maximum operating pressure: 5.5 bar*
should be installed to the cold supply should be installed to should be installed to the cold supply to prevent backflow the cold supply the cold supply
Produo
ied, you should , you should
ied ied , you should , you should
to prevent backflow, a to prevent backflow to prevent backflow