Orientating the Tilt Hinged Feet Components
Orient feet bases separated by a few inches as shown below. Place a set of two (2) screws at the top and
bottom of each foot. Position hinge from bag marked: ST-11A-140SB-50 on left. Position hinge from bag
marked: SA-11A-140SA-50 on right side. Each hinge is also marked on bottom with "A" and "B" for easy
identification.
Install Plugs in Feet
Insert two each of the plastic plugs into each foot as shown below.
Page 5
© 2016 FlexRadio Systems, v1.0.1