Page 1
S T I G A P A R K 92 M 1 07 M 1 07 M H D 1 21 M 11 0 Comb i P r o 12 5 Comb i P r o 8211-0543-03...
Page 2
125 Combi Pro 110/125 Combi Pro 121 M 107 M HD 110/125 Combi Pro Torx T30 F Torx T30 7 121 M 110/125 Combi Pro 110/125 Combi Pro 107 M HD 121 M 110/125 Combi Pro 8 121 M 10 mm 10 mm...
Page 3
9 92/107 92/107 M 13 107 M HD 10 92/107 13 mm 13 mm 10 mm 12 92/107 M 110/125 Combi Pro...
Page 4
92/107 M 107 M HD 121 M 92/107 M 121 M 5 mm 110/125 Combi Pro 107 M HD...
Page 5
110/125 Combi Pro 92/107 M 107 M HD 121 M 24 Nm P 24 Nm Q 9,8 Nm 110 Combi Pro 45 Nm 107 M HD 125 Combi Pro 24 Nm...
Page 6
E.g. “See 2.3.2”. ENGLISH 2 DESCRIPTION 2.1 General The cutting deck is intended for use on Stiga’s 4- wheel drive Park machines. The cutting deck is supplied in one of the follow- ing versions: • With manual adjustment of cutting height.
Page 7
2.3.3 Rear mounting The cutting deck’s rear section is secured with the pins in fig. 13. 2.4 Controls, 92/107 M 2.4.1 Cutting height adjustment The cutting height can be adjusted between 30 and 85 mm. The setting can be adjusted to a number of fixed positions using the lever.
3.2 Installation of 107 M HD, 121 M 1. Place the cutting deck in position in front of the machine. 2. Install the following components on both wheel axles: • Washer (3:B). • Deck mount (3:C). • Washer (3:B). • Circlip (3:A). 3.
3.5.2 Basic setting, 92/107 M, 121 M See fig. 17 and perform basic setting of 92/107 M and 121 M as follows: 1. Place the machine on a level floor. Requirements for floor flatness: ±1 mm/m. No slope towards a floor drain or similar may occur in front of or behind the machine.
5 MAINTENANCE 5.1 Preparation All service and all maintenance must be carried out on a stationary machine with the engine switched off. Prevent the machine from rolling by al- ways applying the parking brake. Stop the engine. Prevent unintentional starting of the engine by disconnecting the spark plug cable from the spark plug and remov- ing the ignition key.
See fig. 30. Always check synchronisation after a collision. If there is any suspicion of incorrect synchronisa- tion, contact an authorised Stiga workshop for re- pair work to be carried out. The blades in the 110/125 Combi Pro are freely ro- tating.
Page 12
w w w. s t i g a . c o m GGP Sweden AB · Box 1006 · SE-573 28 T RANÅ S...